The duties shown in this service are dependent on both of these:
- the data you enter
- the tariff information that has been supplied
It is possible that this data will change over time.
About this commodity code
Commodity code 8501 31 00 63
Ready for installation in vehicles or equipment of headings 8432 and 8433, brushless and permanently excited direct current motor with:
- a specified speed of not more than 6000rpm,
- a minimum output of 400W, but not more than 1,3kW (at 12 V), or with a minimum output of 750W but not more than 1,55kW (at 36 V),
- a flange diameter of 85mm or more but not more than 200mm,
- a maximum length of 335mm, measured from the beginning of the shaft to the outer ending,
- a housing length of not more than 265mm, measured from the flange to the outer ending,
- a maximum of two-piece (basic housing including electric components and flange with minimum 2 and maximum 11 bore holes) aluminium diecast or sheet steel housing whether or not with a sealing compound (groove with an O-ring and grease),
- a stator with single T-tooth design and single coil windings in 9/6 or 12/8 or 12/10 topology, and
- surface magnets,
- whether or not with electronic power steering controller,
- whether or not with pulley or coupling,
- whether or not with rotor position sensor
View commodity 8501310063
Ready for installation in vehicles or equipment of headings 8432 and 8433, brushless and permanently excited direct current motor with:
- a specified speed of not more than 6000rpm,
- a minimum output of 400W, but not more than 1,3kW (at 12 V), or with a minimum output of 750W but not more than 1,55kW (at 36 V),
- a flange diameter of 85mm or more but not more than 200mm,
- a maximum length of 335mm, measured from the beginning of the shaft to the outer ending,
- a housing length of not more than 265mm, measured from the flange to the outer ending,
- a maximum of two-piece (basic housing including electric components and flange with minimum 2 and maximum 11 bore holes) aluminium diecast or sheet steel housing whether or not with a sealing compound (groove with an O-ring and grease),
- a stator with single T-tooth design and single coil windings in 9/6 or 12/8 or 12/10 topology, and
- surface magnets,
- whether or not with electronic power steering controller,
- whether or not with pulley or coupling,
- whether or not with rotor position sensor
View commodity 8501310063